Transfer deflector removal
1 Remove the transfer roll assembly. Go to “Transfer roll assembly removal” on page 314.
2 Gently unsnap the transfer deflector from the machine.
3 Remove the transfer
deflector.
4 Remove the screw (A) securing the ground wire to the transfer deflector.
A
5 Remove the ground wire.
Installation warning: When replacing the transfer
deflector,
ensure that the ground wire is properly
replaced.
Bottom side removals
T652, T654, and T656 duplex assembly removal
Note: When removing the duplex drive motor assembly, it does not need to be completely removed from the
machine. It may be allowed to gently hang out of the way by the harness.
1 Remove the duplex drive motor assembly. See “T652, T654, and T656 duplex drive motor assembly
removal” on page 328.
2 Remove the pick arm assembly. See “Pick arm assembly removal” on page 320.
3 Remove the four screws (A) securing the duplex assembly to the machine.
4 Remove the harnesses (B) from the clamp.
4062
Repair information
316
To Next Page
Loading...
