System card assembly removal
Warning—Potential Damage: When replacing the operator panel assembly or the system card assembly,
only replace one component at a time. Replace the required component and perform a POR before replacing
another component. If this procedure is not followed, the printer will be rendered inoperable. Never replace
two or more components without a POR after installing each one or the printer will be rendered inoperable.
Never install and remove the components as a method of troubleshooting components. Once a component
has been installed in a machine, it cannot be used in another machine. It must be returned to the
manufacturer.
CAUTION—POTENTIAL INJURY: This product contains a lithium battery. THERE IS A RISK OF
EXPLOSION IF THE BATTERY IS REPLACED BY AN INCORRECT TYPE. Discard used batteries according
to the battery manufacturer’s instructions and local regulations.
1 Remove the side cover, left. Go to “MPF cam gear removal” on page 337 or “T652, T654, and T656 left
side cover removal” on page 280.
2 Remove the six screws (A) securing the metal shield to the machine.
A
3 Slide the metal shield in the direction of the arrow.
4062
Repair information
283
To Next Page
Loading...
