Action Yes No
Step 5
Check the alignment assembly for proper adjustment. Go to
“Alignment assembly adjustment” on page 268. If necessary,
replace the aligner assembly. Go to
“Alignment assembly
removal” on page 271.
Does the problem remain?
Go to step 6. Problem is solved.
Step 6
Remove the fuser unit assembly, and then check the heat roll and
pressure roll for contamination or cracks. If necessary, replace the
fuser unit assembly. Go to
“Fuser unit assembly removal” on
page 331.
CAUTION—HOT SURFACE: Allow the fuser unit assembly
to cool down.
Does the problem remain?
Contact the next
level of support.
Problem is solved.
No fuse check
Leading edge
Trailing edge
ABC
DEF
Action Yes No
Step 1
Check the media type and printer media settings, and adjust them
if necessary.
Does the problem remain?
Go to step 2. Problem is solved.
Step 2
Check the fuser unit assembly for proper installation, and reinstall
the assembly if necessary.
Does the problem remain?
Go to step 3. Problem is solved.
Step 3
Check the media condition. If necessary, load new, dry,
recommended media, and then reprint the defective image.
Does the problem remain?
Go to step 4. Problem is solved.
4062
Diagnostic information
54
To Next Page
Loading...
