Sensor (standard bin exit) removal
1 Remove standard bin actuator assembly.
2 Release the hooks (A) securing the sensor (standard bin exit) to the assembly.
A
3 Remove the sensor (standard bin exit).
Sensor (toner density) removal
1 Remove the sensor shield assembly. Go to “Sensor shield assembly removal ” on page 313.
2 Remove the two screws (A) securing the sensor (toner density) to the machine.
3 Remove the sensor (toner density).
4 Disconnect the connection (B) to the sensor (toner density).
AB
Standard bin actuator assembly removal
1 Remove the laser cover. Go to “Laser cover removal” on page 289.
2 Disconnect the connection (A) from the standard bin actuator assembly.
4062
Repair information
341
To Next Page
Loading...
