Lexmark T652 - 56 Parallel Port <X> Disabled; 56 Serial Port <X> Disabled; 56 Standard Parallel Port Disabled; 56 Standard USB Port Disabled

4 Connect the power cord to a properly grounded outlet.
5 Turn the printer power back on.
56 Parallel port <x> disabled
<x> is the number of the parallel port.
Try one or more of the following:
• Press the arrow buttons until Continue appears, and then press to clear the message.
The printer discards any data received through the parallel port.
• Make sure the Parallel Buer menu item is not set to Disabled.
56 Serial port <x> disabled
<x> is the number of the serial port.
Try one or more of the following:
• Press the arrow buttons until Continue appears, and then press to clear the message.
The printer discards any data received through the serial port.
• Make sure the Serial Buer menu item is not set to Disabled.
56 Standard parallel port disabled
Try one or more of the following:
• Press the arrow buttons until Continue appears, and then press to clear the message.
The printer discards any data received through the parallel port.
• Make sure the Parallel Buer menu item is not set to Disabled.
56 Standard USB port disabled
Try one or more of the following:
• Press the arrow buttons until Continue appears, and then press to clear the message.
The printer discards any data received through the USB port.
• Make sure the USB Buer menu item is not set to Disabled.
57 Configuration change, some held jobs were not restored
Since the time the jobs were stored on the printer hard disk something has changed in the printer to
invalidate the held jobs. Possible changes include:
• The printer firmware has been updated.
• Paper input, output, or duplex options needed for the print job were removed.
4062
Diagnostic information
176