Lexmark T652 - 58 Too Many Bins Attached; 58 Too Many Disks Installed; 58 Too Many Flash Options Installed; 58 Too Many Trays Attached

• The print job was created using data from a device in the USB port and the device is no longer in the
port.
• The printer hard disk contains jobs that were stored while installed in a
dierent
printer model.
Press the arrow buttons until
Continue appears, and then press to clear the message.
58 Too many bins attached
1 Turn the printer power o.
2 Unplug the power cord from the wall outlet.
3 Remove the additional bins.
4 Connect the power cord to a properly grounded outlet.
5 Turn the printer power back on.
58 Too many disks installed
1 Turn the printer o.
2 Unplug the power cord from the wall outlet.
3 Remove the extra disks.
4 Connect the power cord to a properly grounded outlet.
5 Turn the printer back on.
58 Too many flash options installed
Too many optional flash memory cards or too many optional firmware cards are installed on the printer.
Try one or more of the following:
• Press to clear the message and continue printing.
• Remove extra flash options:
1 Turn the printer
o.
2 Unplug the power cord from the wall outlet.
3 Remove extra flash options.
4 Connect the power cord to a properly grounded outlet.
5 Turn the printer back on.
58 Too many trays attached
1 Turn the printer
o.
2 Unplug the power cord from the wall outlet.
3 Remove the additional trays.
4062
Diagnostic information
177