T656 operator panel door assembly removal
Warning—Potential Damage: When replacing the operator panel assembly or the system card assembly,
only replace one component at a time. Replace the required component and perform a POR before replacing
another component. If this procedure is not followed, the printer will be rendered inoperable. Never replace
two or more components without a POR after installing each one or the printer will be rendered inoperable.
Never install and remove the components as a method of troubleshooting components. Once a component
has been installed in a machine, it cannot be used in another machine. It must be returned to the
manufacturer.
1 Remove the laser cover. See “Laser cover removal” on page 289.
2 Remove the counter balance springs (A) on both sides.
3 Remove the print cartridge cover springs (B) on both sides.
4 Remove the E-clips (C) on both sides securing the links to the hinges, and remove the links.
5 Remove the pins (D) on both sides securing the links.
C
A
B
D
4062
Repair information
310
To Next Page
Loading...
