8 Remove the screw (E).
9 Remove the ground wire (F).
A
C
D
B
F
E
Installation warning: When reinstalling the transfer roll bracket assembly, left, ensure that the bushing
(C), spring (D), and ground wire (F) are properly replaced.
Right transfer roll bracket assembly removal
1 Remove the transfer roll assembly. Go to “Transfer roll assembly removal” on page 314.
2 Remove the inner deflector. Go to “Inner deflector removal” on page 299.
3 Remove the screw (A) securing the transfer roll bracket assembly, right to the machine.
A
4 Remove the transfer roll bracket assembly, right.
4062
Repair information
315
To Next Page
Loading...
