3 Release the two hooks (B).
B
B
A
4 Remove the operator panel latch assembly.
T650, T652, and T654 operator panel door assembly removal
Warning—Potential Damage: When replacing the operator panel assembly or the system card assembly,
only replace one component at a time. Replace the required component and perform a POR before replacing
another component. If this procedure is not followed, the printer will be rendered inoperable. Never replace
two or more components without a POR after installing each one or the printer will be rendered inoperable.
Never install and remove the components as a method of troubleshooting components. Once a component
has been installed in a machine, it cannot be used in another machine. It must be returned to the
manufacturer.
1 Remove the operator panel latch assembly. Go to “T650, T652, and T654 operator panel latch assembly
removal” on page 304.
2 Remove the three screws (A) securing the cover to the assembly.
3 Release the three hooks (B) securing the cover to the assembly.
AABB
4062
Repair information
305
To Next Page
Loading...
