Right side removals
T652, T654, and T656 duplex cooling fan removal
1 Remove the side cover, right. See “T652, T654, and T656 right side cover removal” on page 295.
2 Remove the screw (A) securing the duplex cooling fan to the machine.
3 Disconnect the connector (B) from the duplex cooling fan.
AB
4 Remove the duplex cooling fan.
Installation warning: When replacing the duplex cooling fan, ensure that it is installed as shown in the
picture.
Fuser drive release linkage removal
1 Remove the system card assembly. Go to “System card assembly removal” on page 283
2 Gently unsnap the upper end of the fuser drive release linkage from the machine.
3 Rotate the fuser drive release linkage 90° to release the lower end of the fuser drive release linkage from
the machine.
4062
Repair information
287
To Next Page
Loading...
