Invalid Tray Configuration service check
Action Yes No
Step 1
Place the RFID option above all other optional input trays or place
at least one optional input tray under it.
Does the problem remain?
Go to step 2. Problem is solved.
Step 2
Reinstall the RFID firmware card, RFID interface card, RFID cable,
and RFID option. Go to
“RFID UHF option installation and
removal” on page 402.
Go to step 3. Problem is solved.
Step 3
Replace the RFID option. Go to
“RFID UHF option installation and
removal” on page 402.
Contact next level of
support.
Problem is solved.
Too Many Bins Attached service check
Action Yes No
a Turn o the printer, and unplug it.
b Remove the excess bins.
c Plug in the printer, and turn it on.
Does the problem remain?
Contact next level of
support.
Problem is solved.
Too Many Disks Attached service check
Action Yes No
a Turn o the printer, and unplug it.
b Remove the excess disks.
c Plug in the printer, and turn it on.
Does the problem remain?
Contact next level of
support.
Problem is solved.
Too Many Flash Options service check
Action Yes No
a Turn
o
the printer, and unplug it.
b Remove the excess
flash
options.
c Plug in the printer, and turn it on.
Does the problem remain?
Contact next level of
support.
Problem is solved.
4062
Diagnostic information
191
To Next Page
Loading...
