Lexmark T652 - Waiting; 30 Invalid Refill, Change Cartridge; 31 Replace Defective Cartridge; 32 Cartridge Part Number Unsupported by Device

Waiting
The printer has received data to print, but is waiting for an End‑of‑Job command, a Form Feed command,
or additional data.
Try one or more of the following:
• Press to print the contents of the buer.
• Cancel the current print job.
30 Invalid refill, change cartridge
Remove the print cartridge, and then install a supported one.
31 Replace defective cartridge
Remove the defective print cartridge, and then install a new one.
32 Cartridge part number unsupported by device
Remove the print cartridge, and then install a supported one.
34 Short paper
Try one or more of the following:
• Load the appropriate paper in the tray.
• Press the arrow buttons until Continue appears, and then press to clear the message and
print the job using a dierent paper tray.
• Check tray length and width guides and make sure the paper is properly loaded in the tray.
• For Windows users, check the Print Properties settings to make sure the print job is requesting the
correct paper size and type.
For Macintosh users, check the Print dialog settings to make sure the print job is requesting the correct
paper size and type.
• Check that the paper size is correctly set. For example, if the MP Feeder Size is set to Universal, make
sure the paper is large enough for the data being printed.
• Cancel the current print job.
35 Insucient memory to support Resource Save feature
Try one or more of the following:
• Press the arrow buttons until Continue appears, and then press to disable Resource Save and
continue printing.
• To enable Resource Save after receiving this message, make sure the link
buers
are set to Auto, and
then exit the menus to activate the link
buer
changes. When Ready appears, enable Resource Save.
• Install additional memory.
4062
Diagnostic information
172