High capacity stacker controller card assembly (upper and lower) removal
1 Remove the high capacity stacker controller card cover panel. Go to “High capacity stacker controller card
cover panel removal” on page 392.
2 Disconnect the harnesses from the controller card.
Note: Pay careful attention to where the power input and output harnesses are attached.
3 Remove the two screws (A) securing the high capacity stacker controller card assembly and remove the
card.
A
High capacity stacker right frame removal
1 Remove the right media output bin recoil spring.
2 Remove the four screws (A) securing the right frame to the high capacity stacker assembly.
4062
Repair information
395
To Next Page
Loading...
