Lexmark T652 - Font Sharpening; Wiper Messages; Key Repeat Initial Delay

This setting allows you to erase the contents of the hard disk.
1 From the Configuration menu, select Wipe Disk.
2 To uc h Wipe disk (fast) or Wipe disk (secure), and then touch Ye s to continue.
Note: Erased data is unrecoverable.
Font Sharpening
Note: This is not supported when the device generates an output at 600 dpi resolution.
This setting allows you to set a text point-size value below which the high‑frequency screens are used when
printing font data.
1 From the Configuration menu, select Font Sharpening.
2 Increase or decrease the value.
Notes:
• The values for this setting range from 0 to 150. 24 is the factory default setting.
• This setting aects PostScript, PCL, and XL.
3 Depending on your printer mode, touch Submit or press the Select button to apply the changes.
Wiper Messages
1 From the
Configuration
menu, select Wiper Messages.
2 Select On or O.
Note: On is the factory default setting.
3 Depending on your printer model, touch Submit or press the Select button to apply the changes.
Key Repeat Initial Delay
Note: This is applicable only to model T656.
This setting determines the length of delay before a repeating key starts repeating. The range is 0.25–5
seconds, with increments of 0.25. One second is the factory default setting.
1 From the Configuration menu, navigate to Key Repeat Initial Delay.
2 Adjust the setting.
3 Tou ch Submit to apply the changes.
4062
Service menus
260