Key Repeat Rate
Note: This is applicable only to model T656.
This setting indicates the number of presses per second for repeating keys. The range is 1–100. 15 presses per
second is the factory default setting.
1 From the Configuration menu, navigate to Key Repeat Rate.
2 Adjust the setting.
3 Tou ch Submit to apply the changes.
Clear Custom Status
Executing this operation erases any strings that have been defined by the user for the default or alternate
custom messages.
1 From the
Configuration
menu, select Clear Custom Status.
2 Press the Select button to start the operation.
USB Speed
Note: This is applicable only to model T656.
This setting is used to set the throughput of the USB port on the printer.
1 From the Configuration menu, select USB Speed.
2 Set the setting to Auto or Full.
Note: Auto is the factory default setting. When set to Full, the USB port runs at full speed and its
high‑speed capabilities are disabled.
3 Tou ch Submit to apply the changes.
Best Speed
Note: This is applicable only to models T650, T652, and T654.
1 From the
Configuration
menu, select Best Speed.
2 Set the setting to For short jobs or For long jobs.
3 Press the Select button to apply the changes.
4062
Service menus
261
To Next Page
Loading...
