Media tray assembly
It is necessary to adjust the media tray rear guide and media tray side guide of the media tray assembly to
match the media size.
Rear media guide
The rear media tray guide assembly can be adjusted to dierent media sizes by moving it to the front or rear.
The rear guide should come into contact with the media and hold it in position.
Side guide
The media tray assembly is designed so it can adapt to the media width in the media feed direction by moving
the side guide to the left or right.
Wear strips
The wear strips are designed to provide a
fixed
resistance to ensure that a single piece of paper is properly
fed out of the media tray. There are several types of wear strips available for custom or hard to feed media.
Duplex
Layout of media transport path
The main components associated with the media path and transport with the duplex installed.
4062
Appendix C: Theory of operation
552
To Next Page
Loading...
