When the pick rolls pick up media, the remaining media decreases, and the media out actuator will lower and
interact with the sensor (media low) and sensor (media empty) to determine the amount of media remaining.
The pick arm assembly (autocompensator) is a paper pick device that generates its own normal force. This
force generation is inherent in the fundamental design of the pick arm. If light media is used, it picks very gently.
If a heavy media is used, it picks very aggressively. No customer adjustments are necessary, therefore no special
trays are needed for card stock or labels. The gearing in the arm is designed so the input torque from the motor
produces a movement about the pivot of the arm. This movement produces a downward force at the pick rolls.
The friction between the pick roll and the paper produces a frictional locking condition. If the paper is physically
held and not allowed to feed, then the motor stalls. Slippage between the roll and the paper is theoretically
impossible. When the motor is energized, the pick rolls are driven down into the stack, increasing the normal
force and drive force until the bending strength of the paper is overcome and the paper bends and moves up
the wear strip.
Switch (media size)
This switch (media size) sets the size of media supplied from each media tray assembly. A signal indicating the
media size is transmitted as a voltage to the printer system card assembly.
Sensor (media empty)
If media runs out in a media tray assembly, the actuator lowers and the actuator flag, unlocks the sensing area
of the sensor (media empty). The sensor light is transmitted. When the sensing area is blocked (media is present),
the signal is o.
Sensor (media low)
This sensor detects by the actuator position whether media in the media tray assembly is low. When the flag
of the actuator blocks, then unblocks the sensing area of the sensor (media low), the media level is determined
to be low.
MPF
The MPF is a mechanical unit supplying media to the printer. The driving force from the main drive motor drive
motor is transmitted to the MPF pick roll to feed media.
4062
Appendix C: Theory of operation
524
To Next Page
Loading...
