3 Close the operator panel door assembly.
4 Remove the four screws (A) securing the main drive motor assembly to the machine.
5 Gently remove the main drive motor assembly.
6 Disconnect the connection (B) from the main drive motor assembly.
A B
Installation warning: Ensure that all electrical connections are properly replaced.
Installation warning: When replacing the main drive motor assembly, ensure that the operator panel
door assembly is in the closed position or the main drive motor assembly will not align properly and
damage will occur.
Installation warning: When replacing the main drive motor assembly, ensure that all gears and drive
shafts are properly aligned, or damage will occur.
MPF pick solenoid assembly removal
Note: The MPF lift plate assembly can be detached and allowed to hang by the harness. The connection
does not need to be disconnected.
1 Remove the MPF lift plate assembly. Go to “MPF lift plate assembly removal” on page 300.
2 Remove the side cover, left. Go to “MPF cam gear removal” on page 337 or “T652, T654, and T656 left
side cover removal” on page 280.
4062
Repair information
275
To Next Page
Loading...
