T656 Operator panel cover latch assembly removal
1 Lift the operator panel cover assembly.
2 Remove the ten screws (A) securing the operator panel cover latch assembly to the operator panel cover
assembly.
3 Remove the operator panel cover latch assembly.
Sensor shield assembly removal
1 Remove the inner
deflector.
Go to “Inner
deflector
removal” on page 299.
2 Gently unsnap the sensor shield assembly from the machine.
A
3 Remove the sensor shield assembly.
Installation warning: When replacing the sensor shield assembly, ensure that the spring (A) is properly
aligned and the sensor shield assembly opens and closes properly.
4062
Repair information
313
To Next Page
Loading...
