Lexmark T652 - 53 Unformatted Flash Detected; 54 Serial Option <X> Error; 54 Network <X> Software Error; 54 Standard Network Software Error

53 Unformatted flash detected
Try one or more of the following:
• Press the arrow buttons until Continue appears, and then press to stop the defragment
operation and continue printing.
• Format the
flash
memory. If the error message remains, the
flash
memory may be defective and require
replacing.
54 Serial option <x> error
<x> is the number of the serial option.
Try one or more of the following:
• Check that the serial cable is connected correctly and is the proper one for the serial port.
• Check that the serial interface parameters (protocol, baud, parity, and data bits) are set correctly on the
printer and host computer.
• Press the arrow buttons until Continue appears, and then press to continue printing.
• Turn the printer o and then back on to reset the printer.
54 Network <x> software error
Try one or more of the following:
• Press the arrow buttons until Continue appears, and then press to continue printing.
• Turn the printer o and then back on to reset the printer.
• Upgrade
(flash)
the network
firmware
in the printer or print server.
54 Standard network software error
Try one or more of the following:
• Press the arrow buttons until Continue appears, and then press to continue printing.
• Turn the printer o and then back on to reset the printer.
• Upgrade (flash) the network firmware in the printer or print server.
55 Unsupported option in slot <x>
<x> is a slot on the printer system board.
Try one or more of the following:
1 Turn the printer power o.
2 Unplug the power cord from the wall outlet.
3 Remove the unsupported option card from the printer system board.
4062
Diagnostic information
175