Securely clearing disk space
The printer hard disk wiping process needs to recover. The message clears when all blocks are cleared.
Serial <x>
The printer is using a serial cable connection. The serial port is the active communication link.
Some held jobs were lost
Try one or more of the following:
• Press the arrow buttons until Continue appears, and then press to clear the message and
continue printing.
• Cancel the current print job.
Staples <x> empty or misfed
Load the specified staple cartridge into the finisher to clear the message and continue stapling.
Staples <x> low or missing
Load the specified staple cartridge in the finisher to clear the message.
Standard Bin Full
Remove the stack of paper from the standard exit bin to clear the message.
Submitting selection
Wait for the message to clear.
Too many failed panel logins
The printer is now in a lockout mode because:
• You attempted to log in too many times with an incorrect PIN
• You attempted to log in using an incorrect password number for access to a printer feature, setting, or menu
that you do not have access to.
Note: There is a defined limit on the number of login attempts. Once the limit is reached, this message
appears and the printer enters a lockout mode. The message remains on the printer control panel, and any
further attempts to enter menus is denied until the defined time out expires. The time out duration is set by
your system support person.
Wait for the message to clear once the time out expires, and then:
• Enter the correct PIN to access any held jobs
• See your system support person if you need a password number to enter a
specific
printer feature,
setting, or menu that is blocked from your use without the number.
4062
Diagnostic information
170
To Next Page
Loading...
