Lexmark T652 - Page 219

Action Yes No
Step 3
Replace the duplex drive motor assembly. Go to
“T652, T654, and
T656 duplex drive motor assembly removal” on page 328.
Does the problem remain?
Contact the next
level of support.
The problem is
solved.
Fuser hot roll control code service check
Action Yes No
Turn o the machine, and then turn it back on.
Does the problem remain?
Contact the next
level of support.
The problem is
solved.
Fuser (920.00–920.04) failure service check
Action Yes No
Step 1
Turn o the machine, and then turn it back on.
Does the problem remain?
Go to step 2. The problem is
solved.
Step 2
Check if the fuser unit assembly is properly installed.
Does the problem remain?
Go to step 3. The problem is
solved.
Step 3
Check if the proper voltage fuser is installed in the machine.
Does the problem remain?
Go to step 4. The problem is
solved.
Step 4
Replace the fuser unit assembly. Go to
“Fuser unit assembly
removal” on page 331.
Does the problem remain?
Contact the next
level of support.
The problem is
solved.
4062
Diagnostic information
219