4 Remove the inner deflector. Go to “Inner deflector removal” on page 299.
5 Remove the MPF pick solenoid assembly. Go to “MPF pick solenoid assembly removal” on page 275.
6 Remove the two screws (B) securing the alignment assembly to the machine.
B
Note: The adjuster screw (C) requires a hex wrench to loosen and tighten.
Note: The adjuster screw (C) can be accessed through the hole (D) in the system card.
7 Completely loosen the adjuster screw (C) securing the alignment assembly to the machine.
4062
Repair information
272
To Next Page
Loading...
