4
Operation
Operation
e3861554
6
2
5
Log in and switch on the truck:
Actuate the parking brake.
Fold up the armrest support (4
).
Place a valid transponder on the reading
area (2).
Data is read in, and LED (5) and LED (6) both
illuminate green. The truck is switched on.
Remove the transponder.
NOTE
If LED (5) and LED (6) flash red, the transpon-
der was invalid or there was a reading error.
After a delay time, the input unit reverts to
login mode and both LEDs alternately flash
green. The delay time increases each time an
invalid transponder is used. Placing a valid
transponder on the reading area automatically
reactivates the input unit. LED (5) and LED (6)
both illuminate green.
NOTE
If LED (5) illumina
tes red and LED (6) illumi-
nates green, the da
ta must be read out by the
fleet manager.
Close the armrest support (4).
e3861554
6
2
5
Switch off the t
ruck and log out:
CAUTION
Unwarranted use by unauthorised personnel.
When parking and leaving the truck, the driver must
log out.
Actuate the parking brake.
Fold up the armrest support (4).
Place a valid transponder on the reading
area (2).
The truck is switched off and LEDs (5) and (6)
go out.
Remove the transponder.
Close the armrest support.
110 Operating Instructions – 3888011701 EN – 12/2017
To Next Page
Loading...
