ON-BOARD DIAGNOSTIC
08–02–5
08–02
PID/Data Monitoring Function
• By using the PID/data monitoring function, the monitored item of the input/output signal, as set on the SAS
control module, can be freely selected and read out in real-time.
• The WDS or equivalent is used to read out PID/data monitor information.
PID/data monitor table
B2867 31 6
Poor connection of any SAS control module
connectors
U2017 43 8
Driver-side side air bag sensor (communication
error)
U2018 44 7
Passenger-side side air bag sensor
(communication error)
DTC
System malfunction location
WDS
display
Air bag system warning light
Flashing pattern
Priority
ranking
PID name (definition) Unit/Condition Operation Condition (Reference) Terminal
CCNT_RCM
(Number of continuous DTCs)
• DTCs detected: 1—255
• No DTCs detected: 0
D_ABAGR2
(Driver-side air bag module
(inflator No.2) resistance)
Ohms Under any condition: 1.5—3.7 ohms 1G, 1J
D_CRSH_S
(Driver-side side air bag
sensor status)
OK/
COMM_FAIL/
INT_FAIL
• Sensor normal: OK
• Sensor communication error: COMM_FAIL
• Sensor internal circuit abnormal: INT_FAIL
2Z, 2AA
DABAGR
(Driver-side air bag module
(inflator No.1) resistance)
Ohms Under any condition: 1.5—3.7 ohms 1S, 1V
D_PTENSFLT
(Driver-side pre-tensioner seat
belt circuit status)
NORMAL/
OPEN/
SHRT_GND/
SHRT_B+/
SQ_LOWRES
• Related wiring harness normal: NORMAL
• Related wiring harness circuit open: OPEN
• Related wiring harness short to ground: SHRT_GND
• Related wiring harness short to power supply: SHRT_B+
• Pre-tensioner seat belt circuit resistance low:
SQ_LOWRES
2P, 2S
DR_BUKL
(Driver-side buckle switch
status)
Buckled/
Unbuckled
• Driver-side buckle switch on: Buckled
• Driver-side buckle switch off: Unbuckled
2T
DR_CURTN
(Driver-side curtain air bag
module resistance)
Ohms Under any condition: 1.4—3.2 ohms 2V, 2Y
DR_PTENS
(Driver-side pre-tensioner seat
belt resistance)
Ohms Under any condition: 1.5—3.1 ohms 2P, 2S
DS_AB
(Driver-side side air bag
module resistance)
Ohms Under any condition: 1.4—3.2 ohms 2M, 2O
DS_AB_ST
(Driver-side side air bag
module circuit status)
NORMAL/
OPEN/
SHRT_GND/
SHRT_B+/
SQ_LOWRES
• Related wiring harness normal: NORMAL
• Related wiring harness circuit open: OPEN
• Related wiring harness short to ground: SHRT_GND
• Related wiring harness short to power supply: SHRT_B+
• Air bag module circuit resistance low: SQ_LOWRES
2M, 2O
DS_CURT_ST
(Driver-side curtain air bag
module circuit status)
NORMAL/
OPEN/
SHRT_GND/
SHRT_B+/
SQ_LOWRES
• Related wiring harness normal: NORMAL
• Related wiring harness circuit open: OPEN
• Related wiring harness short to ground: SHRT_GND
• Related wiring harness short to power supply: SHRT_B+
• Air bag module circuit resistance low: SQ_LOWRES
2V, 2Y
To Next Page
