ON-BOARD DIAGNOSTIC
08–02–7
08–02
End Of Sie
OD_PSAB_ST
(Passenger-side side air bag
module circuit status)
NORMAL/
OPEN/
SHRT_GND/
SHRT_B+/
SQ_LOWRES
• Related wiring harness normal: NORMAL
• Related wiring harness circuit open: OPEN
• Related wiring harness short to ground: SHRT_GND
• Related wiring harness short to power supply: SHRT_B+
• Air bag module circuit resistance low: SQ_LOWRES
2I, 2L
P_ABAGR2
(Passenger-side air bag
module (inflator No.2)
resistance)
Ohms Under any condition: 1.4—2.9 ohms 1A, 1D
P_PTENSFLT
(Passenger-side pre-tensioner
seat belt circuit status)
NORMAL/
OPEN/
SHRT_GND/
SHRT_B+/
SQ_LOWRES
• Related wiring harness normal: NORMAL
• Related wiring harness circuit open: OPEN
• Related wiring harness short to ground: SHRT_GND
• Related wiring harness short to power supply: SHRT_B+
• Pre-tensioner seat belt circuit resistance low:
SQ_LOWRES
2G, 2J
PABAGR
(Passenger-side air bag
module (inflator No.1)
resistance)
Ohms Under any condition: 1.4—2.9 ohms 1M, 1P
P_CRSH_S
(Passenger-side side air bag
sensor status)
OK/
COMM_FAIL/
INT_FAIL
• Sensor normal: OK
• Sensor communication error: COMM_FAIL
• Sensor internal circuit abnormal: INT_FAIL
2B, 2C
PS_AB
(Passenger-side side air bag
module resistance)
Ohms Under any condition: 1.4—3.2 ohms 2I, 2L
PS_AB_ST
(Passenger-side side air bag
sensor circuit status)
NORMAL/
OPEN/
SHRT_GND/
SHRT_B+/
SQ_LOWRES
• Related wiring harness normal: NORMAL
• Related wiring harness circuit open: OPEN
• Related wiring harness short to ground: SHRT_GND
• Related wiring harness short to power supply: SHRT_B+
• Air bag module circuit resistance low: SQ_LOWRES
2I, 2L
PS_BUKL
(Passenger-side buckle switch
status)
Buckled/
Unbuckled
• Passenger-side buckle switch on: Buckled
• Passenger-side buckle switch off: Unbuckled
2H
PS_CURTN
(Passenger-side curtain air
bag module resistance)
Ohms Under any condition: 1.4—3.2 ohms 2A, 2B
PS_CURT_ST
(Passenger-side curtain air
bag module circuit status)
NORMAL/
OPEN/
SHRT_GND/
SHRT_B+/
SQ_LOWRES
• Related wiring harness normal: NORMAL
• Related wiring harness circuit open: OPEN
• Related wiring harness short to ground: SHRT_GND
• Related wiring harness short to power supply: SHRT_B+
• Air bag module circuit resistance low: SQ_LOWRES
2A, 2D
PS_PTENS
(Passenger-side pre-tensioner
seat belt resistance)
Ohms Under any condition: 1.5—3.1 ohms 2G, 2J
PS1_STAT
(Passenger-side air bag
module (inflator No.1) circuit
status)
NORMAL/
OPEN/
SHRT_GND/
SHRT_B+/
SQ_LOWRES
• Related wiring harness normal: NORMAL
• Related wiring harness circuit open: OPEN
• Related wiring harness short to ground: SHRT_GND
• Related wiring harness short to power supply: SHRT_B+
• Air bag module circuit resistance low: SQ_LOWRES
1M, 1P
PS2_STAT
(Passenger-side air bag
module (inflator No.2) circuit
status)
NORMAL/
OPEN/
SHRT_GND/
SHRT_B+/
SQ_LOWRES
• Related wiring harness normal: NORMAL
• Related wiring harness circuit open: OPEN
• Related wiring harness short to ground: SHRT_GND
• Related wiring harness short to power supply: SHRT_B+
• Air bag module circuit resistance low: SQ_LOWRES
1A, 1D
PSB_P_ST
(Passenger-side pre-tensioner
seat belt circuit status)
NORMAL/
OPEN/
SHRT_GND/
SHRT_B+/
SQ_LOWRES
• Related wiring harness normal: NORMAL
• Related wiring harness circuit open: OPEN
• Related wiring harness short to ground: SHRT_GND
• Related wiring harness short to power supply: SHRT_B+
• Pre-tensioner seat belt circuit resistance low:
SQ_LOWRES
2G, 2J
RCM_VOLT
(IG1 voltage)
V
• Ignition switch is at ON: B+
• Other: 0
1W
TRAK_SW
(Seat track position sensor
state)
Forward/
Rearward
• Front seat front position: Forward
• Front seat rear position: Rearward
2W, 2X
PID name (definition) Unit/Condition Operation Condition (Reference) Terminal
To Next Page
