Performing an Analysis ASAP 2460 Operator’s Manual
2-40 246-42800-01 - Aug 2013
1. Select Unit > Start Analysis.
2. Select the port to be used for analysis.
3. Click Browse and select a sample information file or click New to create a new sample
information file.
4. Verify the information populated into the sample identification, Density, Mass, Sample + Tube,
and Empty Tube fields. This information is pulled from the selected or newly created file. The
Density value is applicable only if using the Calculate method for the free space determination.
5. Edit the p
o
and Bath temperature fields, if necessary.
6. Click Report after analysis to automatically generate reports when the analysis is complete. On
the Report Settings window, select the report destination. Click OK to return to the previous
window.
To Next Page
Loading...
