15 - 6
■ The total score exceeds the configured threshold
■ The score of auto obtained parameter is 3.
To configure the EWS alarm, follow this procedure:
1. From the EWS page select Setup.
2. Select the Alarm tab.
3. Turn on the Alarm switch.
4. Set the alarm switches for the single parameters listed in the 3 in single
parameter area.
5. Set the alarm switch and threshold of the total score in the EWS Score area.
15.1.5.2 Auto Refreshing Scores
If Auto Refresh Scores is enabled, the monitor can automatically refresh the total score
in the following cases:
■ The total score reaches the configured threshold, or falls from the configured
threshold to a lower score.
■ The score of auto obtained parameter reaches 3, or falls from 3 to a lower score.
To enable the auto refreshing score function, follow this procedure:
1. From the EWS page select Setup.
2. Select the Alarm tab.
3. Turn on the Auto Refresh Scores switch.
15.1.6 Changing EWS Settings
15.1.6.1 Changing the Scoring Protocol
The monitor is configured with a default scoring protocol. To change the scoring
protocol, follow this procedure:
1. From the EWS page select Setup.
2. Set Score.
15.1.6.2 Setting the Score Confirmation Switch
In Continuous Monitoring mode, you can select if confirmation is required before
saving score. Follow this procedure:
1. From the EWS screen select Setup.
2. Set Score Confirmation switch.
◆ Off: the monitor automatically saves the scoring result after the scoring is
completed.
To Next Page
Loading...
Need help?
General
