D - 2
D.1.4 NIBP Physiological Alarm Messages
D.1.5 EWS Physiological Alarm Messages
Note:N represents a numeric. XX represents RR, SpO
2
, BP-S, BP-D, BP-M, PR, Temp, EtCO
2
.
D.2 Technical Alarm Messages
This section lists technical alarms, their default priority, indication on alarm reset, and
the actions that can be taken when an alarm occurs.
Technical alarms give different alarm indicators when the alarm system is reset. In this
section we classify the technical alarms into three categories for easy clarification:
■ A: technical alarms are cleared. The monitor gives no alarm indications.
■ B: technical alarms are changed to the prompt messages.
■ C: the alarm is silenced and a √ appears before the alarm message, indicating that
the alarm is acknowledged.
In the following tables we will use A, B, and C to refer to the indications on alarm reset.
Alarm message
Default
priority
Cause and solution
NIBP-S Extremely
High/NIBP-D
Extremely High/
NIBP-M Extremely
High
High The NIBP value is higher than the NIBP Extreme
alarm high limit. Check the patient’s condition
and check if the alarm limit settings are correct.
NIBP-S Extremely
Low/NIBP-D
Extremely Low/
NIBP-M Extremely
Low
High The NIBP value is lower than the NIBP Extreme
alarm low limit. Check the patient’s condition and
check if the alarm limit settings are correct.
Alarm message
Default
priority
Cause and solution
EWS Score > N High/
Mediate
The total score exceeds the configured alarm limit.
Check the patient condition.
XX score = 3 Mediate The parameter score is 3. Check the patient
condition.
To Next Page
Loading...
Need help?
General
