B - 7
B.2 Radio Regulatory Compliance
The radio device used in this product is in compliance with the essential requirements
and other relevant provisions of Directive 2014/53/EU.
This device complies with Part 15 of the FCC Rules and RSS-210 of Industry Canada.
Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Any changes or modifications to this equipment not expressly approved by Mindray
may cause harmful radio frequency interference and void your authority to operate this
equipment.
The maximum antenna gain permitted complies with the e.i.r.p. limits as stated in RSS-
210.
The maximum antenna gain permitted complies with the e.i.r.p. limits specified for
point-to-point operation, as stated in RSS-210.
• Changes or modifications not expressly approved by the party responsible
compliance could void the user’s authority to operate the equipment.
100 121223
For transmitters at a maximum output power not listed above, the recommended
separation distanced in meters (m) can be determined using the equation applicable to the
frequency of the transmitter, where P is the maximum output power rating of the
transmitter in watts (W) according to the transmitter manufacturer.
Note 1: At 80 MHz and 800 MHz, the higher frequency range applies.
Note 2: These guidelines may not apply in all situations. Electromagnetic propagation is
affected by absorption and reflection from structures, objects and people.
To Next Page
Loading...
Need help?
General
