18 - 21
18.16.6 The Device Discover Tab
Multicast helps device discovery between monitors and between monitors and CMS.
Devices in the same multicast group can be mutually discovered.
Alarms Server Address / Inputs the name or IP address for the
server receiving the alarm data.
Destination IP 0.0.0.0
Port 0 /
Send Alarms Off
Connection
Status
Disconnected
Data + Waveforms and Alarms are for HL7 setup. You can send the realtime data,
waveforms, and alarms from the monitor to the hospital servers via HL7 protocol.
ADT Server Address 192.168.0.100 Input the host name or IP address of
the ADT gateway.
IP Address 192.168.0.100
Port 3502 Input the port of the ADT gateway.
ADT Query Off Selects whether patient information
can be loaded to the monitor from the
ADT server.
Network Test
/
Tests whether the ADT server is
properly connected.
The ADT (admit-discharge-transfer) gateway is normally deployed in the eGateway. You
can obtain patient information from the hospital ADT server through the ADT gateway.
Menu Item Default Setting Function
Menu Item Default Setting Function
Multicast TTL 1 /
Multicast Address 225.0.0.8
Master Server
Address
//
Master Server IP
Address
0.0.0.0
Connected Status Disconnected
To Next Page
Loading...
