A - 6
A.5.8 Wi-Fi Technical Specifications
A.5.9 Wi-Fi Performance Specifications
• All network functions of data communication are designed to operate on a
private network.
A.5.9.1 System Capacity
Number of the monitors supported by a single AP: ≤ 16
Testing conditions are as follows:
■ Each monitor can communicate with the CMS.
■ Only one monitor can transmit history data.
■ The weakest strength of the AP signal where the monitor is located cannot be less
than -65 dBm.
Alarm delay time from
monitor to remote
equipment
The alarm delay time form the monitor to remote equipment is
≤2 seconds, measured at the monitor’s signal output connector.
Standards IEEE 802.11a/b/g/n/ac
Modulation mode BPSK, QPSK, 16QAM, 64QAM, 256QAM
Operating
frequency
2412MHz~2472MHz,
5180MHz~5320Mz, 5500MHz~5700MHz, 5745MHz~5825MHz
Wireless data rate IEEE 802.11a: 6-54 Mbps
IEEE 802.11b: 1-11 Mbps
IEEE 802.11g: 6-54 Mbps
IEEE 802.11n: MCS0-MCS7
IEEE 802.11ac: MCS0-MCS8
Output power <20 dBm (CE requirements, detection mode: RMS)
<30 dBm (FCC requirements, detection mode: peak power)
Working mode Infrastructure
Data security Standard: WPA/WPA2-PSK, WPA/WPA2-Enterprise, WPA/WPA2 CCKM
EAP method: LEAP, EAP-TTLS, EAP-TLS,EAP-FAST, PEAP-MsChapV2,
PEAP-GTC,PEAP-TLS
Encryption: TKIP and AES
To Next Page
Loading...
Need help?
General
