1 - 3
• Ensure that the equipment is supplied with continuous electric power during
work. Sudden power failure may cause data loss.
• Magnetic and electrical fields are capable of interfering with the proper
performance of the equipment. For this reason make sure that all external
devices operated in the vicinity of the equipment comply with the relevant
EMC requirements. Mobile phone, X-ray equipment or MRI devices are a
possible source of interference as they may emit higher levels of
electromagnetic radiation.
• Always install or carry the equipment properly to avoid damage caused by
drop, impact, strong vibration or other mechanical force.
• Dry the equipment immediately in case of rain or water spray.
• Some settings are password protected and can only be changed by
authorized personnel. Contact your department manager or biomedical
engineering department for the passwords used at your facility.
• Do not loop the patient cabling into a tight coil or wrap around the device, as
this can damage the patient cabling.
• Dispose of the package material as per the applicable waste control
regulations. Keep it out of children’s reach.
• At the end of its service life, the equipment, as well as its accessories, must be
disposed of in compliance with the guidelines regulating the disposal of such
products. If you have any questions concerning disposal of the equipment,
please contact us.
1.1.3 Notes
• Put the equipment in a location where you can easily view and operate the
equipment.
• The equipment use a mains plug as isolation means to the mains power. Do
not locate the equipment in a place difficult to operate the mains plug.
• The typical operator's position is in front of the monitor.
• The software was developed in compliance with IEC62304. The possibility of
hazards arising from software errors is minimized.
• This manual describes all features and options. Your equipment may not
have all of them.
• Keep this manual in the vicinity of the equipment so that it can be obtained
conveniently when needed.
To Next Page
Loading...
