D - 1
D Alarm Messages
This chapter lists only the physiological and technical alarm messages. Some messages
appearing on your monitor may not be included. In the “Cause and solution” column,
corresponding solutions are given instructing you to troubleshoot problems. If the prob-
lem persists, contact your service personnel.
D.1 Physiological Alarm Messages
D.1.1 General Physiological Alarm Messages
Note:XX represents a measurement or parameter label, such as NIBP, RR, SpO
2
, CO
2
, PR, and so on.
D.1.2 SpO
2
Physiological Alarm Messages
D.1.3 PR Physiological Alarm Messages
Alarm
messages
Default
priority
Cause and solution
XX High Med XX value has risen above the high alarm limit or fallen
below the low alarm limit. Check the patient’s condition
and check if the patient category and alarm limit settings
are correct.
XX Low Med
Alarm
message
Default
priority
Cause and solution
SpO2 Desat High The SpO
2
value falls below the desaturation alarm limit.
Check the patient’s condition and check if the alarm
limit settings are correct.
Alarm
message
Default
priority
Cause and solution
No Pulse High The pulse signal was so weak that the monitor cannot
perform pulse analysis. Check the patient’s condition,
SpO
2
sensor and measurement site.
To Next Page
Loading...
Need help?
General
