Mindray VS 9 - 11.10.3 Performing Orthostatic BP Measurement; 11.10.4 Changing Orthostatic BP Measurement Settings

11 - 15
5. Evaluation result based on the set criteria:
◆ Negative: the differences are within the acceptable range as per the set
criteria.
◆ Positive: the differences are out of the acceptable range as per the set
criteria.
For details, see 11.10.4.5 Setting Orthostatic BP Evaluation Criterion.
6. Start/Stop standing blood pressure measurement before measurement and clear
data after measurement
7. Start/Stop lying blood pressure measurement
8. Add patient symptoms for result evaluation
11.10.3 Performing Orthostatic BP Measurement
Follow this procedure:
1. Place the NIBP cuff as instructed in 11.6.2 Placing the NIBP Cuff.
2. Swipe on the NIBP area to the left or right to switch to the orthostatic BP measure-
ment screen.
3. Ask the patient to lie flat on the back and select on the top to take lying BP
measurement. The monitor waits for a preset duration and starts measurement
automatically. The time duration is configurable. For details, see 11.10.4.1 Setting
the Lying Duration of Patient.
4. After the lying BP measurement is completed, ask the patient to stand up. Within 1
minute, select on the bottom. The monitor automatically takes several times of
standing BP measurement, depending on your setting of Standing BP Measure-
ment Interval and Maximum Standing BP Measurements. For details, see
11.10.4.2 Setting Standing BP Measurement Interval and 11.10.4.3 Setting the Times
of Standing BP Measurement.
5. Select symptoms if necessary. The list of symptoms are configurable. For details,
see 11.10.4.4 Setting Orthostatic BP Symptoms.
6. Upon completion of measurement, the evaluation result is displayed in the NIBP
area. Select Negative or Positive to check for details.
11.10.4 Changing Orthostatic BP Measurement Settings
11.10.4.1 Setting the Lying Duration of Patient
Follow this procedure:
1. Select the Main Menu quick key → from the Configuration column select
Workflow → input the required password → select .
2. Select on the right of the workflow to be set. Make sure the workflow is
under Spot Check.