Mindray VS 9 - The Field Tab (for the Mindray Custom 2 D Barcode Reader); 18.15 the Record Settings; 18.16 the Network Setup Settings; 18.16.1 the Network Type Tab

18 - 18
18.14.4 The Field Tab (for the Mindray Custom 2D Barcode Reader)
18.15 The Record Settings
18.16 The Network Setup Settings
18.16.1 The Network Type Tab
18.16.2 The LAN1 IP Tab
Menu Item Default Setting Function
Patient ID/First Name/Last Name/
Patient Category/Gender/DOB
Selected Selects desired patient
information to be output by
the barcode reader.
Visit Number/Room No/Bed No/
Age/Department/Custom Field 1 -
Custom Field 4
Unselected
Tab Default Setting Function
Report Layout Patient Name/Patient
ID/Patient Category/
Visit Number/Gender/
Bed No/DOB/Room No
Sets the information to be included in the
reports, and positions of the information
Menu Item Default Setting Function
Monitor Auto (if WLAN is available on your
monitor)
LAN1 IP (if WLAN is not available
on your monitor)
Selects the type of network to be
used.
Auto: the monitor automatically
identify your network type.
Menu Item Default Setting Function
Obtain IP Address Automatically On Automatically gets the IP
address.
Use the Following Address Off IP Address, Subnet Mask,
and Gateway are required.
Obtain DNS address automatically On Automatically gets the DNS
address