3 - 13
1. In the Workflow Setup menu, select on the right of the workflow to be set.
2. Select an area, and then from the popup list select the parameter to be displayed.
◆ You can set up to 3 pages of screens and each page displays up to 4 rows of
parameters, corresponding to the parameter areas displayed on the main
screen.
◆ Select to lock or unlock the first parameter of the first page. If locked, a
is displayed and this parameter is displayed as the first parameter of
each page.
◆ Select to change the current row to a two-tile display area. The
previously selected parameter will be changed to Off.
◆ Select to change the current row to an undivided display area. The
previously selected parameters will be changed to Off.
3.9.2.3 Changing Parameter Settings
After setting the screen layout, you can make preferential settings for each parameter on
the monitor. To access the Parameters Setup menu, in the Edit Workflow menu, select
Parameters Setup.
The settings under the tabs might be different for different departments and work
modes. For details, see the table below:
Tab Menu Item Description Work Mode
NIBP NIBP End Tone If enabled, a reminder tone is issued at the
completion of NIBP measurement.
Both
Display Format Selects the type and sequence of displayed
NIBP readings.
Both
Initial Pressure
(Neo)
Sets the initial cuff inflation pressure for
neonatal patients.
Both
Measurements Sets the number of measurement that can
be performed in Manual NIBP Measurement.
For details, see 11.7.1 Performing Manual
Measurement.
Spot Check
Interval Sets the interval between two auto NIBP
measurement.
Continuous
Monitoring
Start Mode Defines how NIBP auto mode works.
For details, see 11.8.3 Selecting NIBP Start
Mode--not a task.
Continuous
Monitoring
Display Alarm
Limits
Sets whether to display the alarm limits of
diastolic NIBP and mean NIBP.
Continuous
Monitoring
Patient Position Sets the patient position for NIBP
measurement.
Both
To Next Page
Loading...
