F1: Program Mode
4-21
4
Motion 4000
• DOORS TO OPEN ON ALT FIRE?
• Choices are FRONT, REAR, or BOTH. Determines which door(s) should open once the
car has completed an Alternate Fire return.
• LEAVE DOORS OPEN ON CTL?
• When set to YES, and the CTL (car to lobby) input is active, once the car has returned
to the lobby the doors will remain open instead of cycling closed.
• LIMITED DOOR RE-OPEN OPTION
• Once the doors begin to close after a door dwell time has expired, if a re-opening
device input (PHE or SE) is activated, this option allows the doors to re-open as long as
the re-opening device is active. Once the re-opening device is inactive, the doors will
immediately begin to close again. Without this option set, in this same case, the doors
will re-open fully for a (short door) time and then close.
• REDUCE HCT WITH PHOTO EYE
• Causes a normal hall call time to be shortened to a short door time if a photo eye input
is seen.
• LEAVE DOORS OPEN ON EPI
• When set to YES, and EPI (Emergency Power) input is active, once the car returns to
the emergency power return floor the doors are left open instead of cycling closed.
• DOORS TO OPEN IF NO DEMAND: (NONE/FRONT/REAR/BOTH)
• When set to NONE, the doors remain closed when the car is at a landing with no
demand. When set to FRONT, REAR, or BOTH, the corresponding doors automati-
cally open and remain open when the car is at a landing with no demand. The BOTH
option is not available if the car is programmed for sequential door operation. (See
“SEQUENTIAL DOOR OPER. (F/R)?” on page 4-18.)
• CONST. PRESS OP. BYPASS PHE?
• Used to indicate if Constant Pressure Operations, such as Independent Service, Atten-
dant Service, or if the Constant Pressure Door Close option is set to YES, should bypass
the Photo Eye when the Photo Eye is active and there is a demand to close the doors
and move the car. When set to YES, the car will bypass the Photo Eye and nudge the
doors closed. When set to NO, the car will not bypass the Photo Eye. The doors will
remain open until the Photo Eye is cleared.
• DOOR TYPE IS HORIZONTAL / VERTICAL
• Used to indicate if the doors open horizontally or vertically. When set to vertical,
requires constant pressure on the door close button (DCB) to shut the doors when exit-
ing Fire Phase 2 away from the recall floor with Fire Phase 1 active (ASME A17.1
requirement).
• FRONT DOOR MECH. COUPLED? YES/NO
• Set to YES if the front car gate is mechanically coupled to the hallway doors. To satisfy
A17.1-2000 code requirements, this option is used to qualify the HD Redundancy fault
when the Retiring Cam Option is set to YES and this option is set to YES. (See “RETIR-
ING CAM OPTION?” on page 4-19)
To Next Page
Loading...
Need help?
General
