PC Board Quick References
5-43
5
Motion 4000
Table 5.3 HC-CTL Board Terminals
Connector Terminal Description
J1 2MV Provides 120VAC to 2L bus when SAFL and SAFS relays are picked (input).
2L Provides 120VAC to valves and motor signals when doors are locked and safety
string is made up (Output).
J2 WP1 not currently used
WP2 not currently used
WP3 not currently used
WP4 not currently used
J3 X4 120VAC from power transformer (input)
1 1 bus (ground)
F2FS Provides 120VAC to fire service sensors and signals
J4 DO1 Door open function (Output that signals the controller to attempt to open the
doors)
DCP Door close power
DCF Door close function (Output that signals the controller to attempt to close the
doors)
N1 Nudging (Output that signals the controller to attempt to close the doors at
reduced torque)
J5 SPIN1 Programmable spare input #1
SPIN2 Programmable spare input #2
SPIN3 Programmable spare input #3
SPIN4 Programmable spare input #4
SPIN5 Programmable spare input #5
SPIN6 Programmable spare input #6
J6 Internal CAN connection
J7 1 1 bus (Ground)
2 2 bus (120 VAC)
GS1 Rear door lock string input (Controllers without rear doors should have a jumper
between GS1 and GS2) (used for board interconnections)
GS2 Rear door lock string output (used for board interconnections)
DZR2 Rear Door zone (Output) (used for board interconnections)
DZR1 Rear Door zone (Input) (used for board interconnections)
2S Provides 120VAC to the gate switch, inspection access switch, and door locks
SAFC When this signal is low, in-car stop is activated. ESC terminal provides 120VAC to
this signal during fire recall (In car stop switch bypass)
J8 Used to program the U26 microcontroller
J9 Used to program the U28 microcontroller
J10 SPIN7 Programmable spare input #7
SPIN8 Programmable spare input #8
SPIN9 Programmable spare input #9
SPIN10 Programmable spare input #10
To Next Page
Loading...
Need help?
General
