Appendix
A-20 Manual # 42-02-2P24
175 Danger Start Jerk
176 Danger Roll Jerk
177 Danger Stop Jerk
178 Danger Deceleration
179 Alternate Start Jerk
180 Alternate Roll Jerk
181 Alternate Stop Jerk
182 Alternate Acceleration
183 Alternate Deceleration
184
Drive Type: Select the drive used in the con-
troller.
185 Brake Type Option
186 Emergency Brake Option
187 Reduced Inspect Speed
188 Unintended Motion
189 Following error
190 Sheave Brake Idle Delay
191 Landing System
192
Speed Drop Delay: Magnetek drives only. Time
in milliseconds during which the drive should
continue to exert motor control after the car
has achieved the floor and before the brake
has dropped.
193
Profile Compensation:
Dynamic: Variable, controller determined
compensation for drive lag based on entry in
parameter 140, Profile Advance.
Fixed: Fixed compensation for drive lag using
the parameter 140, Profile Advance setting.
194 Normal Brake Pick Voltage
195 Normal Brake Hold Voltage
196 Normal Brake Relevel Voltage
197 Normal Brake Lift Rate
198 Normal Brake Drop Rate
199 Emergency Brake Type
200 Emergency Brake Pick Voltage
201 Emergency Brake Hold Voltage
202 Directional Limit Type
203 Landing System Floor Checksum
204 Landing System ETS Overspeed
205 Inspection Slew Filter
206 Battery Backup Speed
Table A.3 F7 Parameter Log
ID# Description Setting
To Next Page
Loading...