Program 90 : Maintenance Program
90-05 : Slot Control
1030 Programming Aspila EX Software Manual
90-05 : Slot Con trol
Description
Use Program 90-05 : Slot Control to close (turn off) or delete (uninstall) circuit boards (slots
1-16).
Delete allows you to completely uninstall the PCB. You might want to do this if you want to
remove a PCB and plug it into a different slot - and still retain the port assignments. If a different
type of interface card is being installed into a slot previously used (example; changing from a
ATRU to DSTU PCB), the slot should be deleted (option 1) first before installing the new interface
card.
Reset allows you to send a reset code.
Input Data
Conditions
When you delete or reset a PCB, you must first remove it from its slot then run Program 90-05.
When reusing the slot for another PCB, you must plug the PCB in or reset the system before the
system will use the slot again.
Feature Cross Reference
None
Level:
Aspila EX
IN •Available.
Menu Number 1- Delete
2- Reset
Slot Number
1-16
To Next Page
Loading...
