Program 44 : ARS/F-Route Setup
44-02 : Dial Analysis Table for ARS/F-Route Access
910 Programming Aspila EX Software Manual
44-02 : Dial Analy sis Table for ARS/F-Ro ute Access
Description
Use Program 44-02 : Dial Analysis Table for ARS/F-Route Access to set the Pre-Transaction
Table for selecting ARS/F-Route.
• Service Type 1 (Extension number)
The number goes to an extension after deleting the front digit(p).
Additional data
Assign the digit(p) to be deleted on top of the number for extension number usage. There
must be at least one digit deleted.
• Service Type 2 (ARS/F-Route select)
The number is controlled by ARS/F-Route table.
Additional data
Assign the ARS/F-Route table number for Program 44-05. (If the ARS/F-Route Time sched-
ule is not used.) Assign the ARS/F-Route selection number for Program 44-04. (If the ARS/
F-Route Time schedule is used.)
• Service Type 3 (Dial Extension Analyze Table select)
The total length of the number exceeds more than 5 digits.
Additional data
Assign the referring Dial Extension Analyze Table number for Program 44-03.
Input Data
Level:
Aspila EX
IN •Available.
Dial Analysis Table Number 1-120
Item No. Item Input Data Default
01 Dial Up to 8 digits No setting
02 Service Type 0- No setting
1- Select extension call
2- Select “ARS/F-Route Table”
3- Select “Dial Extension Analyze Table”
0
To Next Page
Loading...
