Pulse to Tone Conversion
300 Features Aspila EX Software Manual
Pulse to Tone Conversion
Description
An extension can use Pulse to Tone Conversion on trunk calls. Pulse to Tone Conversion lets a user
change their extension’s dialing mode while placing a call. For systems in a Dial Pulse area, this
permits users to access dial-up services from their Dial Pulse line. The user can, for example:
• Place a call to a tele-banking system over a DP trunk.
• Depending on programming:
Manually implement Pulse to Tone Conversion
OR
Wait 10 seconds.
• Dial the tele-banking security code and desired number. The system dials the digits after the
conversion as DTMF.
Conditions
Pulse to Tone Conversion is only valid for Dial Pulse trunks (Program14-02-01, options 0 or 1).
Default Setting
Enabled.
Programming
•14-02-07 : Analogue Trunk Data Setup - DP to DTMF Conversion Options
For each trunk, set the type of DP to DTMF Conversion required: automatic (0), automatic
and manual (1), or manual (2).
Related Features
Central Office Calls, Placing
Other programmed options for outgoing calls can affect how a call is placed. Check or pro-
gram these options as needed.
Operation
To convert your phone’s dialing to tone after placing your call on a pulse line:
1. Place call over pulse line.
2. Dial # to switch the DP trunk to DTMF dialing.
Aspila EX
• Available
To Next Page
Loading...
