Program 20 : System Option Setup
20-18 : Service Tone Timers
Aspila EX Software Manual Programming 643
20-18 : Service Tone Timers
Description
Use Program 20-18 : Service Tone Timer to set the values for the system service tone timers.
Refer to the following chart for a description of each option, its range and default setting.
Input Data
Conditions
None
Level:
Aspila EX
IN •Available.
Item
No.
Item Input Data Default Description
Related
Program
01 Extension Dial Tone
Time
0-64800 120 After getting Intercom dial
tone, a keyset user has this
interval to dial the first digit of
the Intercom call.
02 Busy tone timer 0-64800 15
03 Congestion tone 0-64800 10 A Busy Tone when system
resources run short. (such as
DTMF receiver resources)
04 Call Waiting Tone
Timer
0-64800 10 This option sets the interval
between Call Waiting tones.
This timer also sets the inter-
val between Off Hook Signal-
ing alerts.
05 Keyset Confirmation
Tone
0-64800 10
06 Interval of call wait-
ing tone
0-64800 10
07 Intrusion Tone
Repeat Time
0-64800 0 After a call is interrupted
(such as Barge In, Voice Mail
Conversation Recording,
Voice Over, etc), the system
repeats the Intrusion Tone
after this interval. Normally,
you should enter 0 to disable
this interval.
08 Conference Tone
Interval
0-64800 0
09 Warning Beep Tone
Signaling Interval
0-64800 60 14-01-18
To Next Page
Loading...
