NEC ASPILA EX - Program 92: Copy Program; Copy Program

Program 92 : Copy Program
92-01 : Copy Program
Aspila EX Software Manual Programming 1061
Program 92 : Copy Program
92-01 : Copy Progr am
Description
Use Program 92-01 : Copy Program to copy the data for one program to another keyset, port,
group, etc. Refer to the following charts to see which programs which can be copied.
Input Data
Level:
Aspila EX
IN •Available.
Program Number XX-XX
Item
No.
Item Input Data
01 Source Number
Enter the extension, trunk, group, etc.
from which the data will be copied.
• In case of Trunk Base :
Trunk Port Number 1-200
• In case of Trunk Group Base :
Trunk Group Number 1-100
• In case of Extension Base :
Extension Number (up to 8 digits)
• In case of Department Group Base :
Department Group Number 1-64
• In case of DSS :
DSS Console Number 1-32
Destination Number (From)
Enter the first extension, trunk, group,
etc. number to which the information is
to be copied.
Destination Number (To)
Enter the last extension, trunk, group,
etc. number to which the information is
to be copied. If the information is only
be copied to one extension, trunk,
group, etc., enter the information
entered in the Destination Number
(From) entry.