NEC ASPILA EX - DTMF and Dial Tone Circuit Setup

Program 10 : System Configuration Setup
10-09 : DTMF and Dial Tone Circuit Setup
438 Programming Aspila EX Software Manual
10-09 : DTMF and Dial Tone Circuit Setup
Description
Use Program 10-09 : DTMF and Dial Tone Circuit Setup to allocate the circuits on the NTCPU
PCBs for either DTMF receiving or dial tone detection. The NTCPU PCB has 16 circuits initially.
With additional DSPDBs installed, the system can provide a total of 64 circuits (32 + 32). These are
used as follows:
• Extension DTMF receiver for SLT
• Trunk DTMF receiver for analogue trunks, dial tone & busy tone detec-
tion
for analogue trunks
Input Data
Conditions
None
Feature Cross Reference
• Central Office Calls, Placing
• Direct Inward Dialing (DID)
• Direct Inward System Access (DISA)
• Tie Lines
Level:
Aspila EX
IN •Available.
Circuit/Resource Number 01-64
Input Data Default Setting
0- Common use
1- Extension only
2- Trunk only
Circuit/Resource 01-08: 1 (Extension only)
Circuit/Resource 09-32: 2 (Trunk only)
Circuit/Resource 33-64: 0 (Common use)