Program 20 : System Option Setup
20-03 : System Options for Single Line Telephones
Aspila EX Software Manual Programming 607
20-03 : System Options for Single Line Telephones
Description
Use Program 20-03 : System Options for Single Line Telephones to set up various options for
Single Line Telephones.
Input Data
Level:
Aspila EX
IN •Available.
Item
No.
Item Input Data Description Default
Related
Program
01 SLT Call Waiting
Answer Mode
0 = Hook Flash
1 = Hook Flash + Service
code (894)
For a busy single line (500/
2500 type) telephone, set the
mode used to answer a
camped-on trunk call.
For ESL sets, enabling this
option (1) allows the user to
dial Service Code 754 for
Voice Mail Conversation
Record.
011-12-47
02 Ignore Received DP
Dial on DTMF SLT
Port
0 = Do Not Ignore
1 = Ignore
Use this option to define
whether the system should
receive dial pulse and DTMF
signals (0) or ignore dial
pulse and only accept DTMF
signals (1).
015-03-01
03 SLT DTMF Dial to
Trunk Lines
0 = Receive all dialed
data, before sending.
1 = Direct through out
• Type 0 : The system
keeps the digits dialed by
the SLT on a trunk in a
buffer. After all the digits
have been received, the
system sends all the dig-
its to the trunk. If the
time space between dig-
its is longer than the
timer in Item 4, the sys-
tem considers all digits
received.
• Type 1 : The system
passes the received dig-
its from the SLT to the
trunk immediately. If the
SLT has a Last Number
Dial key without a pause,
this key may not be able
to use the Last number
dialing key with the Type
1 setting.
020-03-04
To Next Page
Loading...
