Program 11 : System Numbering
11-09 : Trunk Access Code
Aspila EX Software Manual Programming 491
11-09 : Trunk Access Code
Description
Use Program 11-09 : Trunk Access Code to assign the trunk access code (normally 9). The trunk
access code can be set from 1 to 8 digits which is defined to type 3 and 4 in Program 11-01. This is
the code extension users dial to access Automatic Route Selection. The Individual Trunk Access
Code is used when Trunk Group Routing is desired for an outgoing line.
Input Data
Conditions
None
Feature Cross Reference
• Automatic Route Selection
• Central Office Calls, Placing
• Trunk Group Routing
Level:
Aspila EX
IN •Available.
Caution
The digit 9 is defined in Program 11-01 as Dial Type 3 with the Number of Digits
Required set to 1. If you change the trunk access code in Program 11-09, you must
make the corresponding changes in Program 11-01.
Item
No.
Item Input Data Default Description Related Program
01 Trunk
Access
Code
Dial
(Up to 4 digits)
9 Use this program to
assign the trunk access
code (normally 9). This
is the code extension
users dial to access Auto-
matic Route Selection.
• 11-01 : System Numbering
• 14-01 : Trunk Basic Data Setup
• 14-05 : Trunk Group
• 14-06 : Trunk Group Routing
02 Alternate
Trunk
Route
Access
Code
Dial
(Up to 4 digits)
No setting Use this program to
define additional trunk
access codes.
When a user dials the
Alternate Trunk Route
Access Code, the system
routes their call to the
Alternate Trunk Route.
• 11-01 : System Numbering
• 14-01 : Trunk Basic Data Setup
• 14-05 : Trunk Group
• 14-06 : Trunk Group Routing
• 21-02 : Trunk Group Routing for
Extensions
• 21-15 : Alternate Trunk Group
Routing for Extensions
To Next Page
Loading...
