Program 26 : ARS Service
26-03 : ARS Dial Treatments
Aspila EX Software Manual Programming 767
26-03 : ARS Dial Tre atments
Description
Use Program 26-03 : ARS Dial Treatments to assign the 15 Dial Treatments for automatic ARS
Dialing translation. Assign Dial Treatments to Service Numbers (Trunk Groups) in Program 26-02.
The ARS Dial Treatment options are:
•3 - Delete the NPA if dialed as part of the initial call.
•2 - Delete the leading digit if dialed as part of the initial call.
•1 - Add a leading 1 if not dialed as part of the intitial call.
•INPA - Insert the NPA specified by NPA.
• DNN - Outdial the NN number of digits or execute the code that follows. For example,
D041234 out-dials 124. Valid entries are 0-9, #, *, Wnn (wait nn seconds) and P (pause). Each
digits code counts as a digit. So for example, if a P was added for a pause, the entry would
look like: D05P1234. This Dial Treatment can only be added from telephone programming.
•Wnn - Wait nn seconds.
•P - Pause in analogue trunk.
•R - Redial the initially dialed number, including any modifications
•E - End of Dial Treatment. All Dial Treatments must end with the E code.
•X - When ARS is enabled, X must be entered in the Dial Treatment in order for the sysstem to
output the extension number of the call’s originator to the black box for the E911 feature.
Input Data
Conditions
None
Feature Cross Reference
l Automatic Route Selection
Level:
Aspila EX
IN •Available.
Dial Treatment Table Number 1-15
Item No. Input Data Default
01 24 characters maximum No Setting
To Next Page
Loading...
