NEC ASPILA EX - DID Translation Number Conversion

Program 22 : Incoming Call Setup
22-11 : DID Translation Number Conversion
706 Programming Aspila EX Software Manual
22-11 : DID Translation Nu mber Convers ion
Description
Use Program 22-11 : DID Translation Table Number Conversion to specify for each Transla-
tion Table entry (2000):
• The digits received by the system (eight max.)
• The extension the system dials after translation (24 digits max.)
• The name that should show on the dialed extension’s display when it rings (twelve characters
max.)
• The Transfer Target-1 and 2
If the Transfer Targets are busy or receive no answer, those calls are transferred to
the final transfer destination (Program 22-10).
• Operation mode
Use the following chart when entering and editing text for names. Press the key once for the first
character, twice for the second character, etc. For example, to enter a C, press “2” three times.
Level:
Aspila EX
SA •Available.
Key for Entering Names
Use this keypad digit . . . When you want to. . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ‘ { | }
¬ ®
Press repeatedly to scroll through the list. After selecting your entry, press the
next letter or use the left scroll or right scroll Soft Key to move the cursor.
2 Enter characters A-C, a-c, 2. After selecting your entry, press the next letter or
use the left scroll or right scroll Soft Key to move the cursor.
3 Enter characters D-F, a-f, 3. After selecting your entry, press the next letter or
use the left scroll or right scroll Soft Key to move the cursor.
4 Enter characters G-I, g-i, 4. After selecting your entry, press the next letter or
use the left scroll or right scroll Soft Key to move the cursor.
5 Enter characters J-L, j-l, 5. After selecting your entry, press the next letter or
use the left scroll or right scroll Soft Key to move the cursor.
6 Enter characters M-O, m-o, 6. After selecting your entry, press the next letter
or use the left scroll or right scroll Soft Key to move the cursor.
7 Enter characters P-S, p-p, 7. After selecting your entry, press the next letter
or use the left scroll or right scroll Soft Key to move the cursor.
8 Enter characters T-V, q-v, 8. After selecting your entry, press the next letter
or use the left scroll or right scroll Soft Key to move the cursor.
9 Enter characters W-Z, w-z, 9. After selecting your entry, press the next letter
or use the left scroll or right scroll Soft Key to move the cursor.
0 Enter characters:
0 ! “ # $ % & ‘ ( )
Press repeatedly to scroll through the list. After selecting your entry, press the
next letter or use the left scroll or right scroll Soft Key to move the cursor.